Lenze E94AYCPM Bedienungsanleitung PDF herunterladen (Seite 32)

6 Commissioning

6.3 Possible DIP switch settings

Lenze · E94AYCPM communication module (PROFIBUS®) · Communication Manual · DMS 12.0 EN · 11/2012 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Setting the station address via the »Engineer«

In the »Engineer«, the station address can be set via the Settings tab.

Invalid addresses are displayed in red in the Station address input field (code C13899

/ C14899).

Save the changed settings via the device command C00002 = 11 (save start parameters).

6.3.2 Establishing EMF2133IB compatibility

Establishing EMF2133IB compatibility is necessary if you need to communicate with systems using

an EMF2133IB PROFIBUS communication module.

Software compatibility can be set via DIP switch 2133.

Switch Switch position Function

2133 ON Establishing EMF2133IB compatibility

OFF No EMF2133IB compatibility

 Note!

• In the compatibility mode "EMF2133IB", only the DRIVECOM parameter data channel

(DP-V0) and the Lenze device control can be used.

• Switch off the voltage supply of the communication module and then on again in

order to activate changed settings.

 Communication manual for the EMF2133IB module

Here you can find information on the configuration of the EMF2133IB communication

module and the identification of the module on the bus.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 124 125

Keine Kommentare

Lenze E94AYCPM Bedienungsanleitung Seite 32