Lenze ECS series Bedienungsanleitung PDF herunterladen (Seite 25)

Safety

General safety and application notes for Lenze m otors



EDKCSXX0XX DE/EN/FR/ES/IT 4.0

Installation

Ensureaneven surface,solidfoot orflange mountingand exactalignment ifa directclutch

isconnected. Avoid resonanceswith the rotationalfrequency anddoublemains frequency

which may be caused during assembly. Turn rotor by hand, listen for unusual slipping

noises. Check the direction of rotation when the clutch is not active (observe section 5 ).

Useappropriatetoolsto mountor remove belt pulleysand clutches (heat generation!) and

cover them with a touch guard. Impermissible belt tensions must be avoided (technical

list).

The machines are half-key balanced. The clutch must be half-key balanced, too. The visible

outstanding part of the key must be removed.

If required, provide pipe connections. Designs with shaft end at bottom must be protected

withacover whichpreventstheingression offoreign particlesinto thefan. Freecirculation

of the cooling air must be ensured. The exhaust air - also the exhaust air of other machines

next to the drive system - must not be taken in again immediately.

Electrical connection

All operations m ust only be carried out by qualified and skilled personnel when the

low-voltage machine is at standstill and when the machine is de-energized and protected

against unintentional restart. This also applies to auxiliary circuits (e.g. brake, encoder,

separate fan).

Check safe isolation from the supply!

If the tolerances in EN 60034-1; IEC 3 4 (VDE 0530-1) - voltage ±5 %, frequency ±2 %, wave

form, symmetry - are exceeded, more heat will be generated and the electromagnetic

compatibility will be influenced.

Observe the indications on the nameplate, operating notes, and the connection diagram

in the terminal box.

The connection must ensure a continuous and safe electrical supply ( no loose wire ends);

use appropriate cable terminals. The connection to the PE conductor must be safe. The

plug-in connector must be bolt tightly (to stop).

The clearances between blank, live parts and earth must not fall below 8 mm at V

≤

550

V, 10 mm at V

≤

725 V, 14 mm at V

≤

1000 V.

The terminal box must be clean and dry; foreign particles, dirt and moisture disturb

operation. All u nused cable entries and the box itself must be sealed against dust and

water. For the trial run without output elements, lock the key. Check brake operation

before commissioning of low-voltage machines with brakes.

Show/Hide Bookmarks

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 73 74

Kommentare zu diesen Handbüchern

Keine Kommentare

Lenze ECS series Bedienungsanleitung Seite 25

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Lenze ECS series