Lenze S94P01B2 Bedienungsanleitung PDF herunterladen (Seite 22)

S94P01B2

Interface

Note 3 - Digital Input A3

The ENABLE pin (IN_A3, P3.29) must be wired through a switch or an output on a

front-end controller to digital input common (IN_ACOM, P3.26). If a controller is present,

it should supervise the PositionServo 940’s enable function. The ENABLE circuit will

accept 5-24V control voltage.

Wiring the ENABLE Switch:

Pin 6 +5V

P n 5 GND

P n 26 N A COM

Pin 29 IN A3

CONTROLLER /O

Power Supply

Pin 26 IN A COM

Pin 29 IN A3

CONTROLLER /O

4.1.8 P11 - Resolver Interface Module (option)

PositionServo drives can operate motors equipped with resolvers. Resolver connections

are made to a 9 pin D-shell female connector (P11) on the resolver option module

E94ZARSV2 (scalable) or E94ZARSV3 (standard). When the motor proﬁle is loaded

from the motor database or from a custom motor ﬁle, the drive will select the primary

feedback source based on the motor data entry.

When using a Lenze motor with resolver feedback and a Lenze resolver cable, the

pins are already conﬁgured for operation. If a non-Lenze motor is used, the resolver

connections are made as follows:

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 75 76

Keine Kommentare

Lenze S94P01B2 Bedienungsanleitung Seite 22