Lenze E84Dxxxxx Bedienungsanleitung PDF herunterladen (Seite 40)

3 Safe configuration

3.6 Safety bus

40

Lenze · 8400 protec · Drive-based safety · Software Manual · DMS 2.4 EN · 05/2013 · TD05

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

PROFIsafe parameter

These PROFIsafe parameters and contents are supported:

[3-10] Supported PROFIsafe parameters

Diagnostic messages

Faulty configurations of the PROFIsafe parameters are reported to the safety PLC with a diagnostic

telegram (communication manual PROFINET).

Diagnostic information

GSDML file

All information on the configuration of the PROFINET system is contained in the GSDML file. Thus,

the integration is easy and user-friendly.

PROFIsafe parameter

Name Description Valid contents

F_Source_Add PROFIsafe source address of the safety PLC 0x01 ... 0xFFFE

F_Dest_Add PROFIsafe target address of the safety system

DIP switch:

Code:

0x01 ... 0x03FF

0x01 ... 0xFFFE

F_WD_Time PROFIsafe monitoring time of the safety system 110 ... 65535 ms

F_Check_SeqNr Check of the sequence no. in CRC

V1 mode:

V2 mode:

0

not relevant

F_Check_iPar Check of the iParameters CRC3 in CRC 0

F_SIL Supported SIL (Safety Integrity Level)

SIL1:

SIL2:

SIL3:

0

1

2

F_CRC_Length Length of CRC

V1-mode/2-byte-CRC:

V2-mode/3-byte-CRC:

1

0

F_Block_ID Identification of the parameter type 0

F_Par_Version Version of the safety layer

V1 mode:

V2 mode:

0

1

F_Par_CRC cyclic CRC is calculated

Error number Description

64 The set PROFIsafe target address does not comply with the F_Dest_Add parameter.

65 The F_Dest_Add parameter has the invalid value 0x0000 or 0xFFFF

66 The F_Source_Add parameter has the invalid value 0x0000 or 0xFFFF.

67 The F_WD_Time parameter has the invalid value 0 ms.

68 The F_SIL parameter does not have the valid value 0 ... 2.

69 The F_CRC_Length parameter does not have the valid value 1.

70 The version of the PROFIsafe parameter set is wrong.

71 CRC1 error

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare