Lenze E94P PositionServo with MVOB Bedienungsanleitung PDF herunterladen (Seite 125)

PM94H201B_13xxxxxx_EN L 123

Reference

Table 65: Parameter Settings for External Torque/Velocity Mode

MVOB Folder Sub-Folder Setting

Parameters --

Parameter Name Description

Drive Mode Set to [Torque] for Torque Mode; [Velocity] for Velocity Mode

Analog Input (Current Scale) Torque Mode Only: Set to Required Amps per Volt

Analog Input (Velocity Scale) Velocity Mode Only: Set to Required RPM per Volt

Enable Accel/Decel Limits Velocity Mode Only: Set to [Enable] to switch on velocity ramp rates;

Set to [Disable] to switch OFF (accelerate at current limit)

Accel Limit Velocity Mode Only: Set Acceleration Limit in RPM/Sec

Decel Limit Velocity Mode Only: Set Deceleration Limit in RPM/Sec

Reference Set to [External] for external Torque/Velocity Mode

Enable Switch Input Set to [Run] to allow Enable/Disable of the PositionServo to be

controlled via Input A3 (Dedicated Enable)

IO Digital IO

Parameter Name Description

Output 1 Function Output # indicates Digital Output No. 1-4;

Set value to select Output Functionality;

Output Function Values: 1=Not Assigned; 2=Zero Speed;

3=In Speed Window; 4=Current Limit; 5=Run Time Fault; 6=Ready;

7=Brake; 8=In Position

Output 2 Function

Output 3 Function

Output 4 Function

IO Analog IO

Parameter Name Description

Analog Input Dead Band Set Zero Speed Dead Band in mV for Torque/Velocity Reference on

Analog Input 1

Analog Input Offset Set Torque/Velocity Reference Input Offset on Analog Input 1 to

match Controller Offset

Adjust Analog Input Zero Offset Tool to automatically learn the Analog Input Offset

(of Analog Input 1)

Limits Velocity Limits

Parameter Name Description

Zero Speed Velocity Mode Only: Set a bandwidth (around ORPM) for activation of

the Zero Speed Output/Flag. Set digital output function to ‘2’.

At Speed Velocity Mode Only: Set a Target Speed for activation of the At Speed

Output/Flag

Speed Window Velocity Mode Only: Set a bandwidth (around At Speed parameter)

for activation of the At Speed Output/Flag. Set digital output function

to ‘3’.

Compensation --

Parameter Name Description

Velocity P-Gain Velocity Mode Only: Set P-Gain for Velocity Loop

Velocity I-Gain Velocity Mode Only: Set I-Gain for Velocity Loop

Gain Scaling Velocity Mode Only: Apply Scaling Factor to Velocity Gain Set

Note 1: Parameters highlighted in BLUE are mandatory/necessary for operation in this mode.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 139 140

Kommentare zu diesen Handbüchern

Keine Kommentare

Lenze E94P PositionServo with MVOB Bedienungsanleitung Seite 125

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Lenze E94P PositionServo with MVOB