Lenze PROFIBUS Controller-based Automation Bedienungsanleitung PDF herunterladen (Seite 16)

4 The Lenze automation system with PROFIBUS

4.1 Brief description of PROFIBUS

Lenze · Controller-based Automation · PROFIBUS® Communication Manual · DMS 4.3 EN · 04/2014 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Parameter setting

The PROFIBUS stations can be parameterised in different ways.

If field devices are used the parameters of which are completely written to an GSD/GSE file,

PROFIBUS can only be configured with the »PLC Designer«:

• Import of the PROFIBUS slaves' GSD/GSE files into the »PLC Designer« project.

• Set-up of the control configuration and creation of the PLC program

If PROFIBUS configuration is only possible via a PROFIdrive parameter channel, the

parameterisation can also be done using the »Engineer«/»EASY Starter« – depending on the device

type via the following interfaces:

•Ethernet

•CAN

• Diagnostic interface

 Note!

The "L-force Controller as gateway" function is not available in combination with

PROFIBUS. Therefore logging in with the »Engineer« via the controller as gateway is not

possible.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 54 55

Keine Kommentare

Lenze PROFIBUS Controller-based Automation Bedienungsanleitung Seite 16