Lenze HMI Designer Getting Started Bedienungsanleitung PDF herunterladen (Seite 45)

HMI Designer

EDBHMI-DEEN DE/EN 4.0

QKRKT tçêâáåÖ ïáíÜ íÜÉ éêçÖê~ã “péÉÉÇ ÅçåíêçäÒ

The keypad EPM-H310 and the program “Speed control” (H310_93xx.vts) are used to control a

9300 Servo inverter or a 9300 Servo PLC.

mêÉé~ê~íáçåë çå íÜÉ ÅçåíêçääÉê

t~êåáåÖ>

Terminal X5/28 on the controller must always be connected to a switch so that you can immediately

set controller inhibit in case of an emergency.

• Assign control terminals as prescribed (CINH, QSP)

• Connect system bus (CAN) to the keypad via X4

• Load basic configuration:

Ó Servo inverter: Basic configuration 1010

Ó 9300 Servo PLC: Load the sample project “SpeedModelInternal24VSupply_CFG1010FUP.pro”

in DDS version V.05 or “Speed Control V10.pro” in DDS version V1.0/V2.0 into the 9300

Servo PLC.

( 38)

• Configure C0470/1 if necessary to display messages at the keypad

• Set input X5/E3 = High so that the setpoint can be entered via the keypad

qáé>

Prepare the controller using the following documentation:

( Operating Instructions “9300 Servo inverter”) or

( Online Manual “9300 Servo PLC” (on the CD-ROM “Drive PLC Developer Studio”)

`çÇÉë Ñçê íÜÉ Åçåíêçä ÑìåÅíáçåë

The controller is controlled or values at the keypad are displayed using the following codes:

Control/display of Via code Defined in project component

Note

Nmax C0011 Variables

Acceleration time C0012 Variables

Deceleration time C0013 Variables

Nset C0039/1 Variables Input in [%] of Nmax

100 % = C0011

Nact C0051 Variables Display only

QSP C0135, bit 3

Variables

Direct commands

Decimal control word

CINH C0135, bit 9

Message1 C0470/1, bit 0

Device memory areas

Data exchange areas

Information messages

Code must be configured

at the controller

Message2 C0470/1, bit 1

Message3 C0470/1, bit 2

 42, Project Editor

1 2 ... 40 41 42 43 44 45 46 47 48 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare

Lenze HMI Designer Getting Started Bedienungsanleitung Seite 45

Kommentare zu diesen Handbüchern