Lenze TCF Series Bedienungsanleitung PDF herunterladen (Seite 46)

P12 TB-13C FUNCTION SELECT

This selects the function of terminal TB-13C. Closing TB-13C to TB-4 (or opening in the case

of setting 06) activates the selected function. The following functions can be selected:

01 NONE: Disables the TB-13C function.

02 0-10 VDC: Selects a 0-10 VDC signal (at TB-5) as the AUTO speed reference

input.

03 4-20 mA: Selects a 4-20 mA signal (at TB-25) as the AUTO speed reference

input.

04 PRESET SPEED #3: Selects PRESET SPEED #3 as the AUTO speed

reference. The drive will operate at frequency programmed in Parameter 33.

05 INCREASE FREQUENCY: Increases the speed setpoint when using the MOP

function. Refer to Section 10.6.

06 EXTERNAL FAULT: Sets TB-13C as a normally closed external fault input. If

TB-13C is open with respect to TB-4, the drive will fault.

07 REMOTE KEYPAD: Selects the optional remote keypad as the control source.

Refer to Parameter 14 - CONTROL.

08 DB FAULT: Sets TB-13C as a dynamic braking fault input when using the

optional dynamic braking module. When this input is activated by the dynamic

braking module, the drive will trip into a "dF" fault and the motor will coast to a

stop. Refer to the manual included with the Dynamic Braking option.

09 JOG REVERSE: Jog in the reverse direction. In this mode, the drive will JOG

at the speed programmed into Parameter 34 - PRESET SPEED #4. JOG is

not available in Vector Torque mode.

10 ACCEL/DECEL #2: Selects the acceleration and deceleration time

programmed into Parameter 42 - ACCEL/DECEL #2.

WARNING!

When operating in JOG mode, the STOP terminal (TB-1), the AUXILIARY

STOP function (setting 07), and the STOP key on the optional remote keypad

WILL NOT stop the drive. To stop the drive, remove the JOG command.

JOG REVERSE will operate the drive in reverse rotation even if ROTATION

DIRECTION (Parameter 17) is set to FORWARD ONLY.

NOTE

If the drive is commanded to JOG REVERSE while running, the drive will

enter JOG mode and run at PRESET SPEED #4. When the JOG command

is removed, the drive will STOP.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 75 76

Keine Kommentare

Lenze TCF Series Bedienungsanleitung Seite 46