Lenze 2130IB Bedienungsanleitung PDF herunterladen (Seite 20)

How to wire the module

• Only use cables according to the following cable specification.

• Observe the following illustrations concerning the bus connector.

• Make the connection to the controllers using the bus connector.

The bus system is not interrupted if you disconnect the plug from

the controller.

• Connect a terminating resistor at the physical bus ends . This

resistor is integrated in the bus connection plug. You can activate it

by using a switch.

• If the 2130IB bus interface module is not supplied with power any

more, the bus system continues to operate. The connected

controller, however, cannot be called by the host.

• If you want to disconnect individual bus participants, make sure that

the terminating resistors at the physical cable ends remain active.

• Further notes and wiring instructions can be obtained from the

documentation of the control manufacturer.

Connection of the bus cable in the bus connector

1 = 9-pole SubD connector

2 = Guides for the bus cable

3 = Housing screw

4 = Terminating resistor (not connected))

5 = Cable screen; must lay bare

on the metal guide

approx. 6 mm

approx. 11 mm

cable screen

bus cable

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 91 92

Keine Kommentare

Lenze 2130IB Bedienungsanleitung Seite 20