Lenze EMF2133IB Bedienungsanleitung PDF herunterladen (Seite 37)

Commissioning

Activating the bus terminating resistor

l 37

EDSMF2133IB EN 5.0

6.4 Activating the bus terminating resistor

Bus terminating resistor

The PROFIBUS must be terminated by a bus terminating resistor at the physically first and

last station.

The bus terminating resistor is in the bus connector (¶ 128)and is activated using a

switch.

) Note!

ƒ If you want to disconnect individual bus devices, ensure that the bus

terminators at the cable ends remain active.

ƒ Please note that the bus termination is no longer active if ...

– the connector has been disconnected e.g. in service case;

– the voltage supply of the communication module has been switched off.

6.5 Setting the software compatibility

) Note!

If the EMF2131IB communication module is replaced by the EMF2133IB

communication module, ...

ƒ do not change any host settings;

ƒ set the DIP switch S8 to the "ON" position.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 133 134

Keine Kommentare

Lenze EMF2133IB Bedienungsanleitung Seite 37