Lenze E70ACxS Application Sample i700 (PLC Designer v3) Bedienungsanleitung PDF herunterladen (Seite 9)

Lenze · Servo Inverter i700 | Application Sample · DMS 1.0 EN - 09/2012 - TD11 9

Preconditions

System requirements

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

3 Preconditions

3.1 System requirements

3.2 Setting up communication to the Controller

• Connect the Engineering PC to the Controller via a network cable. The »PLC Designer« accesses

the Controller via Ethernet.

• Make the IP settings with the »PLC Designer« afterwards.

 How to check the communication settings:

1. Go to the Device view and double-click the desired Controller.

2. Make the desired settings on the Communication settings tab.

•Click the Add gateway button to insert a gateway.

Engineering PC Controller

Hardware PC/notebook PLC (Logic) from firmware V3.3

Operating system Windows XP Windows CE

Required Lenze software »PLC Designer« from V3.3 Runtime Software

•Logic

• Motion (for this purpose, the

project data must be updated:

"Update Device")

Further requirements -Bus system

• EtherCAT bus system

•EtherCAT node

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 32 33

Keine Kommentare

Lenze E70ACxS Application Sample i700 (PLC Designer v3) Bedienungsanleitung Seite 9