Lenze MC3000 Series Bedienungsanleitung PDF herunterladen (Seite 31)

13435743_EDBM301_v14.0 27

RUN > 460 VAC

DRIVE

STATUS

MOTOR

VOLTAGE

DIRECTION

(FORWARD)

NOTE

During acceleration and deceleration to the SPEED SETPOINT, the

DRIVE STATUS will show the actual drive speed. When the SPEED

SETPOINT is reached, the DRIVE STATUS will change to RUN (or

STOP if the drive is decelerating to a STOP).

13.2.3 MC3000 DISPLAY IN FAULT MODE

When the drive trips on a fault, the display will automatically change to the FAULT display,

which indicates the FAULT MESSAGE:

FAULT: OVERLOAD

DRIVE

STATUS

FAULT

MESSAGE

In FAULT mode, the ENTER key will toggle the display between four screens: FAULT,

SPEED, % LOAD and VAC. The DRIVE STATUS for these displays will be FAULT. An

example is shown below of the drive in the FAULT mode displaying SPEED.

FAULT > 60.00 HZ

DRIVE

STATUS

SPEED

SETPOINT

SPEED

UNITS

DIRECTION

(FORWARD)

NOTE

To clear a FAULT, press the STOP key, issue a remote STOP

command at TB-1, or use TB-13D (refer to Parameter 50 - TB13D).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 83 84

Keine Kommentare

Lenze MC3000 Series Bedienungsanleitung Seite 31