Lenze MC3000 Series Bedienungsanleitung PDF herunterladen (Seite 39)

13435743_EDBM301_v14.0 35

15.3 THREEWIRE START/STOP CONTROL

Shown below is the wiring diagram for a typical three-wire start/stop control scheme,

using momentary contacts (such as pushbuttons) for START and STOP commands.

Also shown is the wiring for a 0-10 VDC or 4-20 mA speed reference signal

STOP

CIRCUIT COMMON

0-10 VDC INPUT

4-20 mA INPUT

CIRCUIT COMMON

START FORWARD

MOMENTARY

STOP CONTACT

1 2 5A 5B 6 10A 12A RXA TXB10B 2 13A 13B 13C 13D 14 15 2

16 17 18

START REVERSE

0-10 VDC or 4-20 mA

SELECT (see Note 3)

FWD REV

(see Note 2)

MOMENTARY

START CONTACT

The TB-2 terminals are internally tied together

NOTES:

1. Momentarily close TB-12A to TB-2 to START, and momentarily open TB-1 to

TB-2 to STOP.

2. If REVERSE direction is required, TB-13C must be set to START REVERSE

(refer to Parameter 49 - TB13C). If REVERSE is not required, connect the other

side of the start button to TB-12A.

3. Program TB-13A, 13B, or 13C to select the appropriate speed reference signal

that will control the drive speed (refer to Parameters 47, 48, and 49). When that

TB-13 terminal is closed to TB-2, the drive will respond to the selected speed

reference signal. In the diagram above, TB-13A is programmed to select either

a 0-10 VDC or 4-20 mA signal.

4. If the contact closure is not made between TB-13A and TB-2 to select a speed

reference, the drive will default to keypad speed control.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 83 84

Keine Kommentare

Lenze MC3000 Series Bedienungsanleitung Seite 39