Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Bedienungsanleitung PDF herunterladen (Seite 40)

Working with the ApplicationTemplate

Mapping the actual machine structure in the »PLC Designer«

Lenze · ApplicationTemplate · 1.3 EN - 04/2013

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

8.1 Mapping the actual machine structure in the »PLC Designer«

The ApplicationTemplate contains a predefined structure that can be extended by the individual

requirements. Carry out the following steps to map the actual machine structure.

8.1.1 Adding devices - EtherCAT bus system

 How to create the control configuration in the »PLC Designer«:

1. Go to the context menu of the target system and use the Add Device command to

extend the control configuration by "EtherCAT master".

 Note!

The following points have to be observed before starting to set up an EtherCAT

configuration in the »PLC Designer«:

• The sequence of the EtherCAT slaves in the device view must correspond to the

physical arrangement of the EtherCAT topology.

• Select the cycle times according to the technical data, from 1 ... 10 ms.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 176 177

Keine Kommentare

Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Bedienungsanleitung Seite 40