Lenze c300 Bedienungsanleitung PDF herunterladen (Seite 95)

11 Remote maintenance and diagnostics

11.5 Activate Windows® CE interface

Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

11.5.2 Virtual Network Computing (VNC)

For the Engineering PC, you need the "Virtual Network Computing" (VNC) software.

• VNC is preinstalled on the controller. (directory: \USBStorage\windows\VNC.exe)

• VNC allows you to operate the controller by remote control from the Engineering PC. In this way,

you will work on a remote PC as if you were sitting directly in front of the controller.

Conditions

• The controller is switched on and connected to the network/Internet.

• The VNC server is started on the controller.

• A VNC client (e.g. VNCviewer) is installed on the Engineering PC.

 How to establish a remote display connection to the controller:

1. Start the VNC server on the controller

• In the »WebConfig«, set the "Activate VNC server"  (CS 95) or

• Execute the \windows\VNC.exe file

2. Start VNC client on the Engineering PC.

3. Enter the IP address of the controller.

Tip: To display the IP address of the controller, go to the Control Panel

(StartSettingsControl Panel) of the controller and select "Network Connections".

[11-3] Remote access to a controller via VNC (example: VNCviewer)

 Note!

The VNC server is not protected by a password. To protect data from unauthorised

access, the server should be deactivated whenever the connection is not needed.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 194 195

Keine Kommentare

Lenze c300 Bedienungsanleitung Seite 95