Lenze Engineer v2.21 Bedienungsanleitung PDF herunterladen (Seite 212)

Inserting & configuring a network

ETHERNET Powerlink network

212

Lenze · Engineer · 2.13 EN - 10/2014

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

9.3.1.1 Inserting nodes

 Tip!

Instead of manually inserting nodes into the network, you can insert the network in the

Insert network dialog box and at the same time highlight the control field entitled Insert

machine application and add nodes in order to automatically insert all existing devices into

the network as nodes.



Inserting a network ( 207)

In the node selection dialog box, the nodes can be selected manually. All communication-capable

devices (e.g. controllers with CAN interface) of the system structure are shown in a tree topology.

In the Node selection dialog box only those nodes are available that have not yet been inserted.

• You can construct a network only out of nodes that also exist in your project as devices capable

of communication.

• The element below a communication-capable device in this connection represents an

individual, independently configurable node interface (not to confuse with the physical bus

connection).

• If a device is provided with several node interfaces which can be configured independently from

each other, it can appear in several networks or in the same network as a multiple node.

 Note!

In the tree view in the Node selection dialog box, only those devices are shown that can

be inserted into the network as nodes.

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 311 312

Keine Kommentare

Lenze Engineer v2.21 Bedienungsanleitung Seite 212