Lenze Engineer v2.21 Bedienungsanleitung PDF herunterladen (Seite 293)

Lenze · Engineer · 2.13 EN - 10/2014 293

Appendix

User motors

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

14.4 User motors

This function is available from »Engineer« HighLevel V2.7!

A user motor saves default values for Lenze controller parameters relevant for the motor. A user

motor can be created in your »Engineer« project (on the basis of the current controller settings of a

controller).

User motors can be saved to a user motor catalogue and can be reused within the same project (or

in other projects).

14.4.1 Creating user motors from controller settings

• Optimise the parameters of a Lenze controller in the »Engineer« project until correct control of

the motor is performed.

• A new user motor can be created from the current settings on the same project tree level.

• The new user motor can e.g. be copied within the project or saved to a user motor catalogue to

be reused in other »Engineer« projects.

 How to create a motor from controller settings:

1. Select a controller in an »Engineer« project.

• A Lenze 9400 HighLine is used as an example:

 Note!

• If the selected drive controller is online, the online values of the respective code are

read in to determine the nameplate data and the default values of the new user

motor.

• If the selected drive controller is offline, the offline values of the code in question are

used to determine the nameplate data and the default values of the new user motor.

1 2 ... 288 289 290 291 292 293 294 295 296 297 298 ... 311 312

Keine Kommentare

Lenze Engineer v2.21 Bedienungsanleitung Seite 293