Lenze Engineer v2.21 Bedienungsanleitung PDF herunterladen (Seite 253)

Lenze · Engineer · 2.13 EN - 10/2014 253

Error messages

Communication entity generator

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Error during writing of parameter value {0} [CECOMP0006]

Transfer mode {0} is not supported [CECOMP0007]

Direction of transfer is not supported [CECOMP0008]

12.4.3 9400 On board

Node cannot be SYNC source and receiver at the same time [CE94CAN0001]

Deviating target version - This can bring about problems with regard to the compilation and the download (expected: {0}

[CE94CAN0002]

Response (Lenze setting printed in bold)

 Error  Warning  Information

Cause Remedy

Parameter value could not be written to the code.

Response (Lenze setting printed in bold)

 Error  Warning  Information

Cause Remedy

The indicated transfer mode is not supported.

Response (Lenze setting printed in bold)

 Error  Warning  Information

Cause Remedy

The indicated direction of transfer (input, output) is not

supported.

Response (Lenze setting printed in bold)

 Error  Warning  Information

Cause Remedy

Reserved

Response (Lenze setting printed in bold)

 Error  Warning  Information

Cause Remedy

The target version stored in the PLC Designer project of

the device specified does not comply with the version

expected by the generator. This can bring about

problems in particular if older PLC Designer projects are

imported.

This error message only is output in developer mode.

Change to the PLC programming tab and open the PLC

Designer project. In PLC Designer, choose and purge the

target system and compile the project again. The project

must be saved before exiting PLC Designer.

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 311 312

Kommentare zu diesen Handbüchern

Keine Kommentare