Lenze PLC Designer R3-x Bedienungsanleitung PDF herunterladen (Seite 47)

Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014 47

Working with the sample projects

Sample project with "Table positioning" application - TablePositioning

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

7.2.6.3 Manual mode ("Manual jog")

The controller can be actuated manually via the visualisation of the L_LCB_TablePositioning block.

• Button  selects the manual (manual jog) mode.

• The control and status panel  contains the FB for actuating the controller.

• The controller can be actuated manually via the visualisation of the L_LCB_TablePositioning

block.

Note: Activate button  to be able to operate the controller via the visualisation.

• Enable the controller via the xDriveEnable FB input to be able to define setpoints manually.

Note: Click the xDriveSetQsp button to activate quick stop.

Further information on the FB can be found in the following section:

L_LCB_TablePositioning

( 120)

•Area  visualises the FB for reading out the errors from the controller.

Further information on the FB can be found in the following section:

L_DCO_ReadDriveParameter

( 105)

 Select mode Control/status panel Activate control via visualisation

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 158 159

Keine Kommentare

Lenze PLC Designer R3-x Bedienungsanleitung Seite 47