Lenze E94AYCEP Bedienungsanleitung PDF herunterladen (Seite 35)

Lenze · E94AYCEP communication module (POWERLINK MN/CN) · Communication Manual · DMS 6.0 EN · 02/2014 · TD17 36

6 Commissioning

6.2 Node address setting

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

6.2 Node address setting

The POWERLINK node address (node ID) is set via the front DIP switches.

[6-1] DIP switch

• The labelling on the housing corresponds to the valencies of the individual DIP switches for

determining the node address (Node ID).

• Lenze setting for DIP switches 1 ... 128 = OFF (invalid value "0")

• Valid addresses in the POWERLINK network for the communication module:

• 240: Managing Node

The Managing Node mode" supports max. 50 nodes.

• 1 … 100: Controlled Node with Lenze module E94AYCEP as Managing Node

• 1 … 239: Controlled Node with Managing Node of another manufacturer

• The corresponding Ethernet IP address of the communication module results from the address

setting of the DIP switches:

IP address: 192.168.100.[Node ID]

 Note!

• Each network node address must only be used once.

• The node address setting in the configuration software (e.g. »Engineer«) and the DIP

switches must be identical for each node.

• Switch the voltage supply of the communication module off and on again to activate

changed settings.

E94YCEP001D

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 147 148

Keine Kommentare

Lenze E94AYCEP Bedienungsanleitung Seite 35