Lenze 9400 Bedienungsanleitung PDF herunterladen (Seite 573)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 573

11 Basic drive functions

11.14 Pole position identification

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

11.14.2 Parameter setting

• Parameterisation dialog in »Engineer«: Tab Application parameters  Dialog level Overview 

All basic functions  Pole position identification

• Short overview of parameters for pole position identification:

11.14.3 Execute pole position identification

Requirements

• The controller inhibit is active.

• The controller has the "Controller not ready" function state.

• The basic function "Pole position identification" is part of the active application.

• No other basic function is active.

Activate basic function

To request the control via the basic function, the PPI_bEnable enable input in the application must

be set to TRUE.

• If no other basic function is active, a change-over to the "Identification of pole position active"

function state is effected and an identification of pole position can be carried out via the control

inputs.

• A successful change to the function state "Pole position identification" is displayed by a TRUE

signal at the PPI_bEnabled status output.

Parameter Info

C02785

Activation of PPI

C02786

Mode of PPI

C02787 Ppi_dnState

C02788 PolePosition Setpoint

C02789 PolePositionIdentification: Dig. signals

Greyed out = display parameter

1 2 ... 568 569 570 571 572 573 574 575 576 577 578 ... 953 954

Kommentare zu diesen Handbüchern

Keine Kommentare