Lenze 9400 Bedienungsanleitung PDF herunterladen (Seite 691)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06 691

13 Diagnostics & fault analysis

13.7 Error messages of the operating system

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

DFIN (MXI2): Signal error enable/lamp control [0x00aa0003]

DFIN (MXI2): Supply cannot be corrected anymore [0x00aa0004]

DFOUT (MXI2): Maximum frequency reached [0x00aa0005]

CAN module (MXI2): Bus off [0x00ac0000]

Module ID (decimal) Error ID (decimal)

170: Extension module - digital frequency in MXI2 3

Response (Lenze setting printed in bold) Setting: C14041 ( Adjustable response)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Digital frequency extension module in MXI2:

Interruption (open circuit) of the signal cable for the

"Enable" signal or no "Enable" signal available.

• Check signal cable for "Enable" signal.

•Check encoder.

Module ID (decimal) Error ID (decimal)

170: Extension module - digital frequency in MXI2 4

Response (Lenze setting printed in bold) Setting: C14042 ( Adjustable response)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Digital frequency extension module in MXI2: The

encoder voltage controlled by the digital frequency input

has reached the voltage limit.

Check encoder.

Module ID (decimal) Error ID (decimal)

170: Extension module - digital frequency in MXI2 5

Response (Lenze setting printed in bold) Setting: C14080 ( Adjustable response)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

Digital frequency extension module in MXI2: Limit

frequency at the digital frequency output reached.

• The digital frequency has reached the limit value set

in C014053

.

Check limit value set.

Module ID (decimal) Error ID (decimal)

172: CAN module in MXI2: CAN dispatcher 0

Response (Lenze setting printed in bold) Setting: C14595 ( Adjustable response)

 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information

Cause Remedy

CANopen communication module in MXI2: "Bus-off"

state

• Received too many faulty telegrams.

• Defective cable (e.g. loose contact).

• Two nodes with the same ID.

• Remove fault (e.g. EMC).

• Remove loose contact, screw down adapter.

• Assign different IDs to nodes.

1 2 ... 686 687 688 689 690 691 692 693 694 695 696 ... 953 954

Kommentare zu diesen Handbüchern

Keine Kommentare