Lenze ETC Motion Control Bedienungsanleitung PDF herunterladen (Seite 294)

ETC−MMI

"Setup" operating mode

7.4

294

EDSTCXN EN 2.0

Target position Target position for the selected axis. Select the desired

axis by means of the <Axis> key (or <Cursor>keys). The

entry must be completed with <ENTER>. <ESC> cancels

the entry and restores the old positions. The function

key is only labelled and enabled if the <Target point

travel> key has been pressed.

Handwheel The handwheel keys are only displayed if a

handwheel is configured in the machine constants.

Traversing the axes via a handwheel. You can select the

axis which you want to traverse by means of the

handwheel via the <Axis> key (or <Cursor> keys).

Handwheel factor Selection of a factor which acts on the traversing speed.

5 handwheel factors are provided (1, 3, 10, 30, 100).

Every time the <Handwheel factor> key is pressed, the

following factor is selected. The function key is only

labelled and enabled if the <Handwheel> key has been

pressed.

back... Back to the previous level.

Datum points...

Reset The actual position of the selected axis is set to zero

(zero shift).

Import The actual position of the selected axis is set to the

entered value.

Correct The actual position of the selected axis is shifted by the

entered value.

S switchover Enter the number of the workpiece coordinate system

(S), complete with <Enter>, cancel with <ESC>. The

entered coordinate system is activated.

back... Back to the previous level.

Tool management... Management of tools and the corresponding change

positions.

Up to 99 tools can be entered and saved. Tool "0" serves

as reference tool and should not be used otherwise. The

tools can be assigned 99 tool magazine positions. Please

note that each magazine position reduces the number

of workpiece coordinate systems (max. 99).

The number of tools and magazine positions managed

in the MMI is determined in the "DelphMMI.ini"

(^ 327). 30 parameters are available for each tool, six

of which have a fixed meaning:

l Tool length

l Tool radius

l Tool life

l Speed

l Magazine position

l Sister tools

The data is made available in the parts program in the P

field (P700 ... P729) when the tool is selected.

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 427 428

Kommentare zu diesen Handbüchern

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Bedienungsanleitung Seite 294

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Lenze ETC Motion Control