Lenze ETC Motion Control Bedienungsanleitung PDF herunterladen (Seite 345)

100

101

PLC programming

Project planning

Configuring I/O modules

8.4

8.4.4

345

EDSTCXN EN 2.0

8.4.4.2 CAN slave configuration

ETC107

Module ID: ID number of the module.

Node ID: The node ID is entered in the CAN parameter tab.

ETCxM Input/Output address: The basic addresses must always be stated as

word addresses. The address defines where the process data of the module

are located within the process image (I/O memory). This also determines to

which PLC task the data will be allocated. The following table shows the

allocation of the process image to the individual PLC tasks:

Task no.

I/O range

from to

1 %W0 %W1023

2 %W1024 %W1535

3 %W1536 %W1791

4 %W1792 %W2047

Further information can be found in the chapter "Addressing" (¶ 349).

ETCxC Input/Output address: The basic addresses must be issued as word

addresses within the range of %QW64 / %IW64 to %QW127 / %IW127.

Further information can be found in the chapter "Addressing" (¶ 349).

Diagnostic address: This field will not be evaluated by the control.

Basic parameters

1 2 ... 340 341 342 343 344 345 346 347 348 349 350 ... 427 428

Kommentare zu diesen Handbüchern

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Bedienungsanleitung Seite 345

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Lenze ETC Motion Control