Lenze EVS9332xP Bedienungsanleitung PDF herunterladen (Seite 397)

Troubleshooting and fault elimination

System error messages

General error messages

9.3

9.3.1



9.3−5

EDSVS9332P EN 5.0−07/2013

RemedyCauseDescriptionFault message RemedyCauseDescription

DisplayNo.

x088 Sd8

SinCos encoder at X8 sends

inconsistent data.

The tracks in the SinCos encoder

are damaged.

Replace SinCos encoder.

Interference level on the encoder

cable is too high.

l Check correct shield

connection of encoder cable.

l Where required, decelerate the

actuation of the fault message

via the filter time constant.

Setting:

– for ECSxS/P/M/A in C0559.

– for 9300 servo cam in

C0575.

SinCos encoder at X8 does not

send any data.

Open circuit. Check cable for wire breakage.

Incorrect encoder connected. Connect SinCos encoder of the

Stegmann company.

SinCos encoder is defective. Replace SinCos encoder.

Supply voltage set incorrectly. Set voltage supply in C0421.

After fault correction: completely

deenergise the device (switch off

24 V supply, discharge DC bus)!

x089 PL Error during rotor position

adjustment (the error is saved

with mains failure protection)

l The rotor position adjustment

was cancelled.

l During rotor position

adjustment with an absolute

value encoder the error Sd7 or

SD8 occurred.

Repeat rotor position adjustment.

 6.8−1

Note: After an Sd7 fault it is

absolutely required to carry out

another rotor position

adjustment. Otherwise the drive

may carry out uncontrolled

movements after controller

enable. The drive must not be

commissioned without a

successfully executed rotor

position adjustment!

x091 EEr External monitoring has been

triggered via DCTRL.

A digital signal assigned to the

TRIP−SET function has been

activated.

l Check external encoder.

l Switch off the monitoring

(C0581 = 3).

0105 H05 Internal fault (memory) Contact Lenze.

0107 H07 Internal fault (power stage) During initialisation of the

controller, an incorrect power

stage was detected.

Contact Lenze.

x110 H10 Heatsink temperature sensor

error

Sensor for detecting the heatsink

temperature indicates undefined

values.

l Contact Lenze.

l Switch off the monitoring

(C0588 = 3).

x111 H11 Temperature sensor error:

Temperature inside the controller

Sensor for detecting the internal

temperature indicates undefined

values.

l Contact Lenze.

l Switch off the monitoring

(C0588 = 3).

x151 P01 Error "negative limit switch". Negative limit switch was

reached.

l Control drive in positive

direction

l Check wiring at X5/E2.

x152 P02 Error "positive limit switch". Positive limit switch was reached. l Control drive in negative

direction

l Check wiring at X5/E1.

x153 P03 Following error

The angle difference between set

and actual position is larger than

the following error limit set under

C0255.

l Increase following error limit

under C0255.

l Switch off the monitoring

(C0589 = 3).

Drive cannot follow the digital

frequency (I

max

limit).

Check drive dimensioning.

1 2 ... 392 393 394 395 396 397 398 399 400 401 402 ... 444 445

Lenze EVS9332xP Bedienungsanleitung Seite 397

Kommentare zu diesen Handbüchern

Lenze EVS9332xP Bedienungsanleitung Seite 397

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Lenze EVS9332xP